In the process of using spreading device, Occasionally it needs to be replaced because of the physical properties of the glue, or cost considerations. In the process of replacing the glue, if we make operational errors, it will result in the pollution of glue, basic operation to replace glue is as follows, it is just for reference; detailed operation, please call for consultation:0411-39525022

Ⅰ.Close the intake valve of A, B materials barrel, to open the exhaust valve to release its internal pressure;

Ⅱ. Remove A, B materials return tube to connect to one side of the barrel of materials and place in the glue container (it can be discarded or recyclable);

Ⅲ. Open metering pump until the glue in the material bucket empty.

Ⅳ.Open the top cover of the material bucket and clean up the residual glue internal completely .

Ⅴ. To input the new glue

Ⅵ. Open the metering pump to release glue for more than 15 minutes, at this time the feeding tube should not be installed back into original place, glue discharge can not be reused, should be abandoned;

Ⅶ. To connect the back feeding tube to the material barrel, give pressure in the barrel, open the metering pump to cycle.

Ⅷ. Glue replacement is completed